www.imoc.co.uk

Hello folks, haven't been about in a while. Hope you're all well. I've a rattle that sounds like it's coming from the top of the engine, from under the cam cover. It's most noticeable around 2000rpm. Is this a likely cause? Or should this move as freely as this? http://i660.photobucket.com/albums/uu...

Yeah, do a how to!

Looks great.

I haven't done it... Yet. Like i say that was quite a while ago, i would do a lot of research first and see what you find, then make a decision, i could have missed something. Just another thing to add to the list for me. I'll probably get a MapECU3 installed and set it when to open and close throug...

Some more reading http://www.imoc.co.uk/forums/viewtopic.php?t=77936&highlight= I done some reading on this a few years ago and came to the conclusion that it would be beneficial to keep the TVIS in and control it with some sort of switch at the right rpm, and the tune both sides of the map, bef...

http://www.mr2.com/forums/turbo-engine- ... hould.html

There's a link in there if how to instal ecu led's.

http://www.caraudiocentre.co.uk/product ... -20255.htm

I fitted these a few years back so i think those will fit ok

aj.extreme wrote:Just for reference i think they look good fitted with the bar removed

My 2p worth

Yeah, and would look even better if they were blended / smoothed in.

What style side ducts are the black ones?

Just block them off

http://www.imoc.co.uk/forums/profile.ph ... 9c9c0e3b07

Always loved how this setup looks..

Ok its getting replaced then. All I need to do is find another now!

Ok, I've had to replace the p/s rear wheel bearing in my car 2 times already, this is the third. so I'm trying to figure out what might be causing this to happen. We came across this, http://i660.photobucket.com/albums/uu330/Snulty/20120501_145349.jpg http://i660.photobucket.com/albums/uu330/Snulty/...

http://m.screwfix.com/p/radiator-compre ... 15mm/39763

Something like this?

Gut the cat I, don't think is required on a rev 2 turbo....?

how about

http://www.ebay.co.uk/itm/270893477705? ... 1423.l2649

Ive read the exedy stage 1 is rated to 280 ftlbs. so the standard one must be a fair bit less?

http://www.ebay.co.uk/itm/320565142876? ... 1423.l2649

What signs of ware? be interesting for those of us with lsd's to know. if you dont already!
i dont.

ahh good. how much was it? im replacing my dizzy cap soon.

oh & BUMP!

theres an O ring seal that goes on before the dizzy cap, if its flatned it might not be sealing properly, pull the dizzy cap off and make sure theres not water in there.

wind deflectors & cruise control

http://www.imoc.co.uk/forums/viewtopic.php?t=152631