manual boost controller?

[Range]

im thinking of uping the boost a little on my rev2, but im running a bit low on funds as iv just spent 500 on shocks, the car feels much more stable and wouldant mind going a bit quicker, any 1 got any ideas?

[Spittinflames]

You answered your own question..... MBC but you will need an FCD too.

Make sure your engines healthy too... and dont go crazy with uppin the boost.

[Range]

MBC FCD ABC HUH? sory im abit slow wots mbc

[paul port]

MBC FCD ABC HUH? sory im abit slow wots mbc

Manual Boost Controller

[Dale V]

mbc - manual boost controller

FCD - Fuel cut defender

[Range]

i new that, i was just checking

[Range]

theres a device attached to the ecu on my car, and its writen on it SPEED CUT DEFENCER its a HKS brand, is this the same as fcd?

[paul port]

theres a device attached to the ecu on my car, and its writen on it SPEED CUT DEFENCER its a HKS brand, is this the same as fcd?

No,
It removes the SPEED limiter (180Km/h)

[Range]

wel surly thats got to do with cuting the fuel off to the engine wen it hits a cirtain speed?

[screech205]

Yes it has mate but that removes the 112mph speed limit, a FCD will remove the fuel cut from when you go above 13psi i think it is. Completely unrelated!

[JAP BOY]

How can you up the boost accurately with a MBc guyz!

I've got a Revision 6 MBC so at the moment i would assume that itz set as standard!

My actuator wont run anything below 14psi of boost! So does this mean that my MBC was setup for more boost i'm just assuming itz just been put on no adjustments

[Range]

ooo riite I GET IT NOW. No 1 told me it stops fueling at 13 psi, so every time i see my boost gauge going past 13 or so the car will stall back agresivly? THAT MUST HAVE BEEN THE PROBLEM WITH MY PRIVIOSE MR2!
AN I THUOGHT THERE WAS SOMETHING WRONG

[Range]

[ye mate that must be it the actuater is too weak for going past 13 or 14 or so ul need a stronger 1 or 1 u can udjust , i think..]How can you up the boost accurately with a MBc guyz!

I've got a Revision 6 MBC so at the moment i would assume that itz set as standard!

My actuator wont run anything below 14psi of boost! So does this mean that my MBC was setup for more boost i'm just assuming itz just been put on no adjustments[/quote]

[JAP BOY]

Hi Range i'm jsu guessing here as my car had a uprated actuator fitted to it!

[Range]

ohh sory i miss understood, i thuoght u meant u couldant hold more than 14psi of boost because of ur actuator... hmm i dont no the answere to ur sitaution mate

[CosmosblueMR2]

How can you up the boost accurately with a MBc guyz!

I've got a Revision 6 MBC so at the moment i would assume that itz set as standard!

you use a Good aftermarket Boost gauge.. set your MBC - take it for a drive (cautiously) and adjust the screw accordingly to set your desired boost limit.

[JAP BOY]

Cheers Cosmos Blue will do that