[Mk2] [Turbo] Gear Selector

[soup_yo]

The Rubber boot has split on the gear selector, does anyone know how to get the end off to enable me to put a new one on? when I undo the nut the bolt going through the arm will not budge!!

[soup_yo]

Damn, put this in wrong section. Should be mechanical sorry

[soup_yo]

Someone must know how to remove this, to enable me to replace the rubber boot that's missing?

[SFLee]

if it is the gear selector it is in BGB,

[bobhatton]

That is not an easy thing to do with the gearbox on a bench so going to be very hard with it in the car.
I had to put a lot of heat into the bolt then shock it with lots of cold water to get it out. Then had to use a puller to get it off the shaft.

I think the new rubber boot £13.35

[soup_yo]

I came to the same conclusion, I was hoping this wasn't the case. I have the rubber boot but I may just use somthing else to protect it that I can slide over the end of the selector, not the best solution