Just Swaped the cam cover seals today with some fresh ones, as the old ones where leaking.

After refitting the cover tightening in sequence and in stages.

The top three Bolt holes where they extend out slight to accomidate the bolts cracked!! and this was not even with an overly ammount of tightness on the bolts

All the others are fine and tightend nicely.

Could this be a side affect from being just over the Exhaust manifold and near the turbo? I know it can get quite hot there.

.

It seems this part of the cam cover has gone britle because of this.

.

.

Now i'm getting even more oil seeping out and splashing onto the heat sheild.

.

which when stationary at lights ect, burns off and smokes out the vents! Quite embarresing

Luckly the oil level has not droped significantly.

But just so annoying.

Will be getting a new cover tommorro to replace.

Anyone else come across this problem before??