Haltech E6K ECU and Sensors - SOLD

[Peter Gidden]

Recently removed from a 460bhp ST185 GT4 is a Haltech E6K ECU complete with loom plug and tails.



The E6K might be old, but it was a leader in its time with sequential injector driving, closed loop fuel control and boost control to 30psi of boost.

Full spec. and manual here:

http://www.haltech.com/wp-content/uploa ... Manual.pdf

Wiring diagram here:

http://www.haltech.com/wp-content/uploa ... omRevF.pdf

Software for programming here:

http://www.haltech.com/wp-content/uploa ... 6Kv634.zip

The software only works in DOS, so an old laptop with a serial port will be required.

Lots of install info here:

http://www.peculierboy.com/haltech/e6k_main.htm

£75 delivered.

[Peter Gidden]

On ebay:

http://www.ebay.co.uk/itm/Haltech-E6K-E ... 1124wt_962

Currently at £84 plus postage. Bidders from Oz, Italy and Israel.

[gavinda]

Dam I would take this for 75 peter. now I have to bid against italy?

[Peter Gidden]

Found a couple of brand new sensors (worth £20+ each), and some other related bits and pieces.

Added to auction.

[Peter Gidden]

Don't say i don't offer you guys bargains!

£225 on ebay and 2 hours to go.

And to the IMOC member that PM'ed me telling me he'd give me £20 "cos tat's all old stuff like that is worth" i trust my finger wasn't to uncomfortable as you swivelled on it... ,

[Tomas_St]

damn pete did nice money on ebay

[archangel]

And to the IMOC member that PM'ed me telling me he'd give me £20 "cos tat's all old stuff like that is worth" i trust my finger wasn't to uncomfortable as you swivelled on it... ,

Lololol

[SonicSW20]

Went for a bit more than £75 quid in the end then!

Out of interest, would you be able to program this from a newer machine with a USB -> RS232 adapter and DOSBox? It would be an easier solution for most people!