Water/meth injection: a theoretical and practical discussion

[2mad]

From a few posts back ......


"Iat gauge test showing cooling (50+ without meth) on very busy roads, couple of 3rd and 4th pulls, +25c ambient temps... http://vid948.photobucket.com/albums/ad ... chedon.mp4


Remember the longer your on boost the colder temps get."

[kev8611]

To be honest. The highest i have seen my inlet temp is 38. Obviously this is just going by what it says on my hand commander using the standard temp sensor so i dont really trust it

[2mad]

To be honest. The highest i have seen my inlet temp is 38.

38c max, that's outstanding if true .


Edit .. was that with or without meth (i forget)

[Ryan S]

Yeah that is low(although depends on the boost i suppose), my CC set up should see around 39degrees at 1.8 bar, I would check it out with a proper temp sensor just for peace of mind anyway, happy days if it is 38degrees though, it'd save you a lot of hassle!

[kev8611]

Yeah theres no way its true lol. Thats without water/meth as I aint bought it yet.

Still trying to decide. Getting a dyno done tomorrow though

[2mad]

Yeah theres no way its true lol. Thats without water/meth as I aint bought it yet.

Still trying to decide. Getting a dyno done tomorrow though

Yeah bit optimistic for a side mount no mater how good an original Greddy is.. hope it is true .


Good luck with the mapping


Ps. think gtschris sells a fast response iat .. not expensive, could be worth a try .. get a more accurate reading or maybe confirm the present .. never now