![](./images/smilies/spacer.gif)
I am in the process of purchasing a complete 4AGZE clip, complete with ECU, loom etc etc
![](./images/smilies/spacer.gif)
A few questions:
![](./images/smilies/spacer.gif)
Do I need to upgrade the pump? I am sticking to the standard size SC pulley for now but I may upgrade in the future
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
I can easily have the N/A engine lid modified and I was going to design a vent that can be welded onto the existing lid for airflow to the IC.
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
But should I make an air duct from the fan/vent pod on the drivers side to the IC? This isn't a real bind either as this can be made at work.
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
Anything I should be aware about being installation?
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
Many thanks in advance.
![](./images/smilies/spacer.gif)
Alex