4 connectors in image, on cam gear cover, currently not connected, have people removed them completely by chasing them back?
Cheers in advance
What do this connectors do?
Moderators: IMOC Moderators, IMOC Committee Members
Re: What do this connectors do?
Intercooler fan connector
AC Compressor connectors
Lambda Sensor connector
Are usually around that area
AC Compressor connectors
Lambda Sensor connector
Are usually around that area
Re: What do this connectors do?
Thanks, as I'm running none of that anymore I'll remove the connectors and wiring
Re: What do this connectors do?
what you doing about your o2 sensor then?
Re: What do this connectors do?
Running a Link G4 according to his project thread so I assume it's running off a wideband instead of the stock sensor.
Re: What do this connectors do?
gotcha!
i only left the o2 wiring in all the way up to the ecu when i shredded the loom in that area..
woulda been nice to completely remove that section
i only left the o2 wiring in all the way up to the ecu when i shredded the loom in that area..
woulda been nice to completely remove that section
Re: What do this connectors do?
Sounds like you need to convert to carbs Jim, no need for any of this electrickery controlled nonsense then
Re: What do this connectors do?
Have you got 3 or 4 connectors there? looks like 3 in the picture but i've got 4 on my Rev 3 one of which not connected to anything.
Intercooler fan connector
AC Compressor connector
Lambda Sensor connector
One not connected...
Intercooler fan connector
AC Compressor connector
Lambda Sensor connector
One not connected...
Re: What do this connectors do?
4th would be cat temp sensor
(i believe)
(i believe)
Re: What do this connectors do?
Yeh I've got 4 all of which are disconnected and have partially melted whilst flapping around, I have no idea what is happening re: o2 sensor, there is a bung on the downpipe where they must have plumbed a wide band sensor for mapping then I don't know for adjustments whilst running? Anyone with more knowledge shed some light or tell me that's mental and should be corrected straight away hah
Re: What do this connectors do?
The ECU will just be using the wideband I would think.
Re: What do this connectors do?
I wasn't very clear, there is no wideband sensor installed now, just a blanked bung on the downpipe, so correct me if I'm wrong but it'll just be running an open loop system whereby the fuel isn't trimmed to suit real world conditions/ o2 feedback, What I'm unsure on is whether this is a good or bad hing, I'm sure people would come up for cases for both.
Re: What do this connectors do?
Ah right. Beyond my paygrade to be honest!
Re: What do this connectors do?
As long as its been mapped properly on idle and cruise then its not such an issue, on boost the Lambda doesnt do anything anyway.
I've still got my lambda connected but turned off, however I do have a wideband lambda to monitor the AFR's from and confirm everything is good on idle/cruise.
I've still got my lambda connected but turned off, however I do have a wideband lambda to monitor the AFR's from and confirm everything is good on idle/cruise.