[Mk2] [NA] Rev 3 vacuum pipe layout

[dubsport01]

Does any one have a vacuum layout for the rev 3+ engine? Can only seem to find the rev 1. The rev3 manual doesn't give a full break down, from what I can see.

Or can any one tell me if the Acis is piped to the vsv behind the intake iris the fuel pressure regulator piped to the vsv?

Rev4 uk if that makes any difference.

[Donato]

Is this of any use?

[dubsport01]

I think my system is slightly different, I have three hoses out the top of my throttle body and an egr on the exhaust manifold.

Thanks for the effort thou

[Peter Gidden]

I think my system is slightly different, I have three hoses out the top of my throttle body and an egr on the exhaust manifold.

Thanks for the effort thou

Like this?

Here's a Rev4 TB:

[dubsport01]

I think my system is slightly different, I have three hoses out the top of my throttle body and an egr on the exhaust manifold.

Thanks for the effort thou

Like this?

Here's a Rev4 TB:

Image Replaced With URL For Quote http://www.sbits.net/pics/rev4natb.jpg

That looks the one! That small pipe coming off the side of the main intake pipe goes to two places. The larger diameter pipe goesgoes to a pipe behind the idle speed control valve I currently have the smaller pipe going to the fuel pressure regulator. Is that correct?

Or should it be going to the acis actuator and the fuel pressure regulator be fed from the vsv?

Thanks

[dubsport01]

that boyo circled, im not sure if my last post made sense lol

basically should that go to the FPR or the ACIS acutaor?

Although if anyone had a rev4 layout handy i could still use it just to confirm all my pipes are correct.

[mr2matt]

Hi

I have a rev5 which should have the exact same pipe setup, I will have a look and try to get some pictures for you later on

[dubsport01]

Thanks bud

[mr2matt]

Sorry I completely forgot all about this

I will try and remember to do this during a break tomorrow for you