- all this stuff is too heavy or large to post economically and without getting damaged.Located in Coventry, CV1.
Standard rev3 rear bumper with blended-in Border spats.
Super red.£75.Professionally installed 2 years ago by Xquisite near Guildford.
The whole bumper was freshly painted when they were installed. Now still looking mostly new, but there are a few small nicks - the worst being a little squiggly line about two inches long at the right front corner at the bottom, where a small child might have scratched with a stone, or some Kwik-Fit muppet slipped with a drill or something. First time I even noticed it was when I was cleaning it up today, so it's not particularly obvious, but I'm trying to be honest!
4x OZ Cronos, 18x7j, ET48.
Subaru 5x100 fitment (but see below for adapters to fit an MR2!)SOLD.Hubcentric PCD adapters/wheel spacers MR2 hubs
> Subaru wheels.2x 28mm thick
2x 48mm thick
SOLD.2x OZ Crono 18x7j, ET38.
MR2 5x114.3 fitment (and I think 5x100 on the other set of holes)£60In need of a refurb.
Been painted black for a while then silver, now all starting to flake off (original paint looks good underneath though). Some kerb rash around the rims, see pictures.Fitted with Falken 452 tyres that are almost bald on the inside inch or so, but basically new on the rest
(I've been running mad camber, yo.)If you're running more than a degree or two of camber, you've probably got two brand new tyres here if you swapped them round!
Standard rev3 spoiler, Super Red.
£25Fine condition, one or two very minor scuffs that you'd probably never even notice.
Standard rev3 Turbo engine lid, Super Red.
£40Paint looking a bit faded, but otherwise in good condition.
One or two minor chips, never bothered me when on the car.Clip that holds the rod stay in place is snapped, unfortunately.
