Discussion and technical advice the SW20 MR2. 3S-GTE, 3S-GE, 3S-FE etc
Anything and everything to do with maintenance, modifications and electrical is in here for the Mk2.
hi,i'm the guy on ebay who does the wheel arch repairs for the MK1 and i get one or two emails every week asking if i do sills for the MK2.
my question to you guys and girls is what is the availability if any and would it be worth me tooling up to make them?
also would you want a skin sill or the full sill?
all the best,Steve
Hi
If you tool up and make the parts I will have a set. I have a Mk2 that is off the road due to a rot problem. It is impossible to cut out a repair section since they all rot in the same place.
Cheers
you can buy the mid sill section, but the front of the full sill comes on the piller section and the rear of the full sill comes with the rear quarter, been there and done this, fortune me lad a fortune.
The wife just had a full pro respray on her NA, part of that was replacing the sills prior to spraying, they went to Toyota who wanted really silly money, through trial and error they found out that For KA sills were near enough the perfect fit, minor bit of modding and sills fitted and look spot on, cost was minimal.
Berk Tech IC, Berk Tech Downpipe, Berk Tech Exhaust, ARC Induction System, DevilsOwn Water/Meth Injection (Pre & Post turbo). TRD Cold Pipe, EMS Powered Digital Boost Gauge, TRD Strut Braces, Innovate O2, Blitz SBC i-color EBC - "ARCH ROLLER FOR HIRE"