What I need to know is if the wiring looms for the revision 1 and 2 are the same as what is found on the revision 3?
Cheers.
[Mk2] [Turbo] Rear cluster looms the same for all revisions?
Moderators: IMOC Moderators, IMOC Committee Members
[Mk2] [Turbo] Rear cluster looms the same for all revisions?
I'm looking at converting my revision 3 rear clusters to the quad light setup so that I don't need a separate fog light hanging below the bumper.
What I need to know is if the wiring looms for the revision 1 and 2 are the same as what is found on the revision 3?
Cheers.
What I need to know is if the wiring looms for the revision 1 and 2 are the same as what is found on the revision 3?
Cheers.
Re: [Mk2] [Turbo] Rear cluster looms the same for all revisions?
The wiring is different.
For the conversion all you need is 2 dual filament bulb holders from any revision MR2, as long as they have a length of wire on them. 
For the conversion all you need is 2 dual filament bulb holders from any revision MR2, as long as they have a length of wire on them.
I asked God for a bike, but I know God doesn't work that way.
Re: [Mk2] [Turbo] Rear cluster looms the same for all revisions?
Yeah, I should have been more clear with my wording. It's specifically the bulb holder that I needed to know was the same across revisions.
Looks like I'm good to go then. I've found 2 looms which are at a much lower price than new 
Cheers, Jaspa.
It's specifically the bulb holder that I needed to know was the same across revisions.Looks like I'm good to go then.
I've found 2 looms which are at a much lower price than new Cheers, Jaspa.
Re: [Mk2] [Turbo] Rear cluster looms the same for all revisions?
Be aware that the rev1-2 dual filament bulb holders and the rev3+ are NOT identical (well either that or the sockets on the middle lenses are slightly differnt to the outer lenses - I did not check). The rev1-2 dual filament holders will fit in the rev3 inner lenses with some wiggling, but will not clamp hard down to form a wateright seal like the other lenses do. When I did my quad light mod I taped them down for a bit of extra security.
(well either that or the sockets on the middle lenses are slightly differnt to the outer lenses - I did not check). The rev1-2 dual filament holders will fit in the rev3 inner lenses with some wiggling, but will not clamp hard down to form a wateright seal like the other lenses do. When I did my quad light mod I taped them down for a bit of extra security.