stud fitments are the same.
would nee to check offsets but should fit IMO.
theres a blue RX8 up my street with the standard wheels powdercoatred white, looks lovely. *edit* http://www.lexusownersclub.co.uk/forum/ ... ded&start= ^^^
a few people have them fitted to mr2's and is200's.
read the replies there
oh thats not mine mate, my mr2 is lambo candy apply blue. that was my brother in laws, very nice mr2 rev 2. its a veilside rear bumper and veilside spoiler or a kind, my car is similar however. thanks for the comment
http://www.imoc.co.uk/forums/viewtopic. ... c&start=60
see the link, i have rx8 wheels on mine, i wouldn't even bother to be honest, i had to fit extended wheel studs to the front and 18mm spacers and get new nuts, the rears are fine but sit a bit too far under the arch in my opinion, really not worth it, only reason i shoved them on is because i had the wheels spare from my rx8
Kongaroo wrote:What's the diameter, width and offset of standard RX8 alloys anyway?
i think they are 8 inch wide, the offset if i remember is ET50, i have 18mm spacers and it JUST clears the strut(i have standard springs), it really is a massive pain in the blllx!!!
The FD wheels are meant to be able to fit some serious tyre under em, I dunno they look more period correct on the MR2 than the RX8 wheels and at least they are staggered I think.
Sheppy - were your RX8 alloys 18" diameter? If they are then I agree it does sound a lot of effort to fit a non-staggered set of 18x8 alloys.
Race - I seem to recall that the standard RX7 FD wheels 16x8 ET50 all around as I had considered buying a set a while back and had looked it up at the time. I may be wrong though.