www.imoc.co.uk

Bump....now £20 delivered

Bump, now £40 plus delivery

Hi guys, I have for sale an active sound system, with sub, amps and wiring loom. I never fitted but I believe it fits behind the passenger side. Looking for £50 plus delivery :) http://i211.photobucket.com/albums/bb9/jcurtis6183/Facebook/Mobile%20Uploads/IMAG1121.jpg http://i211.photobucket.com/albu...

Hi guys, I have a brand new (still boxed) dizzy cap and rotor arm for a Rev3. I got this from MR2 Ben for my old Rev3 Turbo but never fitted it. It cost £37 delivered but I'm looking for £25 delivered . http://i211.photobucket.com/albums/bb9/jcurtis6183/Facebook/Mobile%20Uploads/IMAG1124.jpg http://...

Drop me a PM buddy

Hi guys, I have for sale a triple 60mm gauge pod for the MK dash. This is MR2 MK2 specific and follows the curves of the dash for a nice fit. It certainly feels a little more stock than a pillar pod. Looking for £70 plus delivery. http://i1266.photobucket.com/albums/jj523/jamescurtis6183/IMAG1104_zp...

If this is still available, I will take it

Mine, all mine Alan

Thanks guys. It feels like it's holding back basically around 2.5 - 3k revs then kicks on.
The power is all there beyond that point.

I was thinking maybe an air leak? It's not consistent, sometimes worse than others.

Hi Guys,

The tubby has suddenly developed an issue where the power isn't locking in until higher revs than normal.

When the power comes in its strong as normal but there is definitely a delay, almost like lag.....any ideas on what could cause it?

Let's start with the obvious. What's it like with the Gizmo removed? Any idea where I would run the vacuum hosing to rather than the gizmo? Sorry I've owned her without the boost controller so no clue to the original plumming #-o From turbo compressor to actuator. Ah I'm with you, will try on the w...

Tomas_St wrote:was same problem... found damage hose simple problem

Ah my friend said the same so I swapped a whole load of stock hoses.....which one did you find an issue with?

Peter Gidden - SBITS wrote:Let's start with the obvious.

What's it like with the Gizmo removed?

Any idea where I would run the vacuum hosing to rather than the gizmo? Sorry I've owned her without the boost controller so no clue to the original plumming

Hi guys,

My rev3 tubby has recently started to 'stutter' when reaching approx 0.80 on the gizmo boost controller (set to 1.20).

She runs smooth as ever until that part and still wants to keep pulling until the 'stutter' kicks in.

Any ideas??