www.imoc.co.uk

Peter,
Thank you very much for your help.

Hi, Can anyone help here? We have these for sale, but I need to check if they can be used with the stock ECU? Could they be used with the PowerFC? Can the injector resistor pack be removed and thus allow the use of these injectors? From memory I reckon the stock injectors were low impedance 2.8 ohms...

Hi,
has anyone had water pump failure when running big HP or when raising the rev limit to 8000rpm plus. has anyone installed a davies craig EWP as a replacement???

mitch

cheers mate

hi guys,
can you tell me if rear rev 3 NASP brake calipers are the same as rear rev 3 turbo caliper.????
reason for question is that i want to fit rear rev 3 calipers to my rev 2 turbo.


mitch

cheers mate thanks for that

hi guys.

can some one plz plz plz tell me what the thread is on the fuel preeure regulator.


many thanks mitch

hi guys,
i need front wheel arch liners for a rev 2 turbo! i have been offered some rev 3 inner arch liners are these the same and will they fit??

regards mitch

does any1 know where i can get an adaptor /flange to fit a t3 turbo?

how much are you looking for matey??

is it possible to get the Apexi top mount manifold anywhere?

thats exactly what i have found. i'll make an adaptor to suit the move and a 44mm WG. thanks. Paul

Jim, Thats a result. And somewhere where we thought we would be with our build...but thats a long storey (painfull like yours too at times)!!! OK to ask a couple of questions? The gt3071r turbo in the earlier pics has a Mark 1 ATP turbine housing for the Evo 8-10...Did you use this turbo complete???...

Guys,
I'm thinking about relocating the turbo "up"...I've seen a few manifolds floating around on the net. But, top mount options, anyone help out here. Ideally I want to go top mount AND 44mm wastegate...
Paul.

Hi, To help identify which bush goes where...has anyone already done this? Or is it "obvious"...:-) Description Powerflex vs Toyota Front Anti Roll Bar Bush Ø18 PFF76-303 = 48815 Front Tie Bar Front Bush PFF76-301 = ??? Front Track Control Arm Inner Bush PFF76-302 = ??? Rear Anti Roll Bar ...

related to the HG question...i'm hoping to help out a fellow member with a cracked Rev 2 Block.

I have a Rev 3 Block (with pistons, rods and crank)...can the Rev 2 Head WITH a Rev 3 Head Gasket go together?