www.imoc.co.uk

Had my set today and they look very well made will put a pic up when i fit them on the weekend.

Paul

cantfindausername wrote:Current list:

Apocalypse - FULL KIT - Disclaimer Read & Agreed
Turbo Mr2- FULL KIT - Disclaimer Read & Agreed

Paul T-2 rear kits-Disclaimer read & Agreed

Its ok now just ordered some powerflex ones from larkspeed for £38 posted.

paul

I am using the superflex (yellow) bushes, these are a bit too tight to be honest and make the car shake when at idle :) They rock on hard launches though.... :) Think the pair were £35 - £40 for front and rear mounts (£18 each or so) from grahame good racing, he does a PDF brochure of the mounts. I...

if those are the mesurements of the throttle body then i stand corrected :) i will measure a rev 1 and 3 this weekend to double check. again if you work on m3/m5 and evos then very good for you i dont envy you even less room in engine bay. if i had any of those cars i would take them to a main deale...

The fact that an engine survives a few 1/4 mile run doesn't mean it's well built. To me a well built engine stands the test of time and repeat performs again and again. But thats just my opinion. I use the car day in and day out and its done about 20k with this engine and all the ones i have done i...

yeah paul i do just read things off the net thats why i cant belive you are running 87mm pistons :lol: is 14 years in a garage supposed to impress me. i have taken my cars to them as a last resort before and normally you get a half wit who ends up breaking it even further ](*,) . mind you if a tyre...

the port spacing is diffrent so it wont work and thottle body is not 6mm bigger. having more air go in to the middle of these manifolds is a waste as it leans them out even more. mounting the thottle on the end is the only real safe option. if looking for more power this is one of the last things t...

They are the same as i have a rev3 na one on my rev2 turbo.Paul

I just got hold of a gear box out of a st165 and thanks for the ofter ,you will lose most of your turbo lag with it and where did you get your tyres from as i am hoping to get in the 11s next year ,and then i will be going for a bigger turbo ,getting the running gear all done 1st.

Interesting you say that about bottle location. I was informed that the ideal location was near enough upright.... im in talks with Trevor Langfield so im sure he'll be advising me anyhow. Thats good results with your setup - are you using the maximiser? Na than[/quote] Hi i was using the maximiser ...

Thats the same nos setup as i am running on my car just with out the direct port ,going to do that in the next few weeks ,and it does work well as i have a rev2 engine with a rev3, turbo ecu etc and i did a 12.158 @119.03 when i fitted it a mate who used to sell and fit nos told me not to put the bo...

I did the rev2 to a rev3 ecu conversion on my car last year i just used the looms off a rev3, and i have not had a problem with my car going up to the red line and i am still running rev2 cams only thing i am using is a turbo ,sensors etc off a rev3 turbo,it must be ok as i run a 12.158-1/4mile in ...

phil-p wrote:Cheers. I am just goin to swap the pins about for the ecu and ill have to re wire for the new sensors. What did you do with the TVIS? How long did it take you to do the conversion?


Cheers Phil

Hi i did it when the engine was out as i put a turbo into a na,i removed flaps in the tvis.Paul

I did the rev2 to a rev3 ecu conversion on my car last year i just used the looms off a rev3, and i have not had a problem with my car going up to the red line and i am still running rev2 cams only thing i am using is a turbo ,sensors etc off a rev3 turbo,it must be ok as i run a 12.158-1/4mile in t...

Where the marks are you flat the paint with a 2000 grit paper and then buff the paint back up it will look better or if they are not to deep you may not have to paint it .Paul

The 318 is is not a bad car but i bet you find it so slow after your mr2 but you can still have fun in it , if you want me to see if i can flat and polish your bonnet for you just so it looks better let me know as i only live in burry port.Paul

What bmw have you got your self as i have worked on them for years

pm,ed you his number .Paul

If you want a number of a guy who paints cars in swansea and he does a good price for cash and his paint work is a1 as he worked in bmw with me .Paul