Knowledge Base

should be the same on all mk2's (i think)

remove 4plugs around dissy cap, using the clips "only", dont go pulling the plugs by the leads!! (mark leads with tape like me!) best to use a flat blade screwdriver to undo the clips!!
unclip the coil as well.
use 10mm rachet for 2 bolts around the cap.
take cap off.
unscrew 2 screws holding cap on, remember what position the old one was in, and replace with new!
put dissy on, do up 2 bolts, put in plugs and coil, away you go!!

: Sat May 21, 2005 4:59 pm

Excellent how-to =D>

Not wanting to sound pedantic though, you need an 8mm rachet for the 2 bolts that hold the cap on, not 10mm, at least on a UK rev5 NA.

: Fri Dec 23, 2005 1:25 pm

nice one jim i used 8mm on my bolts i have a rev2 turbo dont use a screwdriver trying to get the nuts out they thread easy as i found out !

: Sat Dec 24, 2005 12:41 pm

my mistake, obviously i must have used 8mm to get the cap off....
[Embarassed]