Replaced the dizzy and the rotor arm after missfirings and idling problems but the problem continues.
![](./images/smilies/spacer.gif)
.
![](./images/smilies/spacer.gif)
.its like I never even replaced these parts.
![](./images/smilies/spacer.gif)
.and my old dizzy and rotor were really knackered too.
![](./images/smilies/spacer.gif)
.
![](./images/smilies/spacer.gif)
.
![](./images/smilies/spacer.gif)
plugs only a year old.
![](./images/smilies/spacer.gif)
Heres what happens
![](./images/smilies/spacer.gif)
: The car on cold start up will idle low at 950-1000.
![](./images/smilies/spacer.gif)
.not 1500 like it
![](./images/smilies/spacer.gif)
should.
![](./images/smilies/spacer.gif)
It'll stay like that for around 30sec.
![](./images/smilies/spacer.gif)
Then there will be a wierd
![](./images/smilies/spacer.gif)
"brrmp brrmp brrrmp" sounds interrupting the steady
![](./images/smilies/spacer.gif)
"brmmmmmm" of the engine and the idle judders about with this sound
![](./images/smilies/spacer.gif)
If I tap the throttle there is a clear delay befor the revs will respond and it has a lot of trouble settling down again.
![](./images/smilies/spacer.gif)
Eventually itll conk out as the above mentioned
![](./images/smilies/spacer.gif)
"bbrmmp brrmp" takes right over and the engine stalls.
![](./images/smilies/spacer.gif)
Ive checked the hosing they are all fine.
![](./images/smilies/spacer.gif)
Ive yet to put in the redex stuff
![](./images/smilies/spacer.gif)
(car ran very low on fuel recently might be clogged injectors im thinking).
![](./images/smilies/spacer.gif)