I have just purchased a Momo F16 gear knob, went to fit it tonight and realised that it sits too high.
![](./images/smilies/spacer.gif)
My question is, is it sensible to cut the gear lever down to size so the Momo sits lower?
I need to cut about 40mm off the lever
![](./images/smilies/spacer.gif)
(just below the threaded section).
![](./images/smilies/spacer.gif)
I realise that I will not be able to fit the standard knob back on if ever I need to but just wondered if any of you guys have had to do this.
![](./images/smilies/spacer.gif)