Just a quick question I have some parts you will never find any where now that I have had stored for 15 years and was looking to see if there would be any interest.
![](./images/smilies/spacer.gif)
I have to dig them out of the depths of the garage but I know they are there!! There will be some surface rust but they are all new and have ZERO miles.
![](./images/smilies/spacer.gif)
I have a brand new in its original Toyota crate short engine.
![](./images/smilies/spacer.gif)
This engine block comes complete with a brand new crank, bearings etc.
![](./images/smilies/spacer.gif)
No ancillaries.
![](./images/smilies/spacer.gif)
I will repeat this is a brand new, never run, factory supplied short engine.
![](./images/smilies/spacer.gif)
I had it balanced with a brand new fidanza flywheel and brand new clutch.
![](./images/smilies/spacer.gif)
I also have a vapour blasted cylinder head fitted with new slim stem valves, new KK294 cams and top quality(cant remember the make) adjustable sprockets.
![](./images/smilies/spacer.gif)
These cams are Canadian and give the highest lift possible whilst still using the original cam followers.
![](./images/smilies/spacer.gif)
I believed they are shimmed about right.
![](./images/smilies/spacer.gif)
( Does the shim bank still exist in the club?
![](./images/smilies/spacer.gif)
) These cams are the dogs danglies and you will get superb performance without having to go for different followers or change the fuelling.
![](./images/smilies/spacer.gif)
Used in Track cars in Canada.
![](./images/smilies/spacer.gif)
I was going to do a super quick sleeper car but things got in the way and it has all been stored.
![](./images/smilies/spacer.gif)
Some may remember me from the distant past at event and the S E area.
![](./images/smilies/spacer.gif)
Just putting out feelers, I will get photos and part numbers later.
![](./images/smilies/spacer.gif)
Now in sunny Wiltshire