rogue fan kit thread bore information?

[demonslayer]

Hi Everyone,

I am trying to find out the threads on the mid-section of the good old rogue fan shroud.
Somehow it must be something m5 -ish. The others surrounding sure are m6.
I am not able to mount my temp sensor at the moment/After reinstalling this kit again.
I know I had the temp sensor mounted once, i see the marks, but I have no clue which bolts I used.
Maybe one of You can check this for me on his/her lid/shroud.

thank you,
Dan


[/img]

[demonslayer]

Hello, can someone help please?

[wilkie senior]

I dont think that are that many Rogue shrouds around to try but surely they would be using the same as the std bolts to fasten the sensor on?

I would suggest you would have more luck contacting Rougue directly?

regards Brian

[wilkie senior]

std bolts would be as i recall m6x1.0 metric bolts

I will have a check round for you

[demonslayer]

Thank you,
I contacted Rogue, and they tried to help me. In any case they dont have such shrouds to check for me, but are certain they used metric tapings.
So I removed the shroud and checked its rear side/ the threads, and realized that powder coat drained into the last section of the threads.

So its M5x0.8 metric for these 2 holes on the sensor.

All other main bolts are M6x1 metric .

mystery solved

Now I have to think about how and where to connect the dual Spals that the temp sensor controls them. As they drain quiet some amps they should go to a Batterie + somewhere.