Well she was fine for a week or 2.
![](./images/smilies/spacer.gif)
.
![](./images/smilies/spacer.gif)
.
![](./images/smilies/spacer.gif)
.
![](./images/smilies/spacer.gif)
However I've had a missfire as it entered boost
![](./images/smilies/spacer.gif)
(seperate thread).
![](./images/smilies/spacer.gif)
Nathan at mrtwos looked over it and found one of my cams was out a tooth which wasn't helping.
![](./images/smilies/spacer.gif)
Turns out it appears to be a faulty ECU.
![](./images/smilies/spacer.gif)
I tried repairing the caps on my ECU and it didn't fix the issue.
![](./images/smilies/spacer.gif)
I then bought a 2nd ECU same issue.
![](./images/smilies/spacer.gif)
Opened it up.
![](./images/smilies/spacer.gif)
Worse leaking Caps than mine had.
![](./images/smilies/spacer.gif)
So I've given up on stock ecus and have nearly finished building this:
![](./images/smilies/spacer.gif)
![Image](https://i.imgur.com/37Q63aV.jpg)
![](./images/smilies/spacer.gif)
Just got to add a spark output on the proto board
![](./images/smilies/spacer.gif)
(as using stock igniter to drive coil) and then wire up a zeal add in board to control tvis and fans.
![](./images/smilies/spacer.gif)
Then my boost controller add on.
![](./images/smilies/spacer.gif)
Get paid Friday so I'm ordering the following:
![](./images/smilies/spacer.gif)
1.
![](./images/smilies/spacer.gif)
AEM wideband
2.
![](./images/smilies/spacer.gif)
Mac boost solenoid
3.
![](./images/smilies/spacer.gif)
Clutch switch
4.
![](./images/smilies/spacer.gif)
Physical switches to enable/disable anti lag/launch control
5.
![](./images/smilies/spacer.gif)
Cone filter as I won't be using the messy MAF setup once this is installed
![](./images/smilies/spacer.gif)
Excited to get her back on road.
![](./images/smilies/spacer.gif)
Aiming for mr2 national day as it's relatively local to me.
![](./images/smilies/spacer.gif)
So pop over and say hello if you see my car.
![thumleft :thumleft:](./images/smilies/icon_thumleft.gif)