Rollingroad Table

What's happening at the Club. You can post your suggestions and ideas here, along with reports of any problems using the site.

Moderators: IMOC Moderators, IMOC Committee Members

Post Reply
KiwiMR2

Rollingroad Table

Post by KiwiMR2 »

Suggestion...........EITHER have 2 seperate one's, rwhp OR fwhp, or make it ONE or the OTHER.

Cheers
KiwiMR2
Al-sw20
Posts: 1623
Joined: Sun Jan 23, 2005 6:01 am
Location: Christchurch, New Zealand
Contact:

Re: Rollingroad Table

Post by Al-sw20 »

rwhp is the international standard, bhp is just to boost your ego.

When my new turbo gets here I'll make sure I dyno higher than you Kiwi :P
KiwiMR2

Re: Rollingroad Table

Post by KiwiMR2 »

Al-sw20 wrote:rwhp is the international standard, bhp is just to boost your ego.



Hehehehe :lol:

When my new turbo gets here I'll make sure I dyno higher than you Kiwi :P


What ya getting?? I better start saving for my dyno tune then.....Power FC arrives on Sunday :twisted: Should go nicely with my recently installed Trust intercooler :P

Cheers
KiwiMR2
Al-sw20
Posts: 1623
Joined: Sun Jan 23, 2005 6:01 am
Location: Christchurch, New Zealand
Contact:

Re: Rollingroad Table

Post by Al-sw20 »

Secret :P

Yeah you need to sort out those dodgy high rpm a/fs. My a/f plot was dead flat at 11:1 8)
Sidewinder
Posts: 2766
Joined: Tue Dec 14, 2004 1:48 pm
Location: Wellingborough (or thereabouts)
Contact:

Re: Rollingroad Table

Post by Sidewinder »

Funny timing on this thread - I was only looking at the RR table yesterday, and was thinking the same thing; two seperate tables would give better results to compare against.
Mk2 NA Rev1 -*- Mk2 Turbo Rev2 -*- Mk1 NA -*- Mk2 Turbo Rev 3 = all gone!
_______________________________________
"Cruisey, Sporty, more innovation, more adult. A Man In Dandism. Powered mid-ship specialty."
Post Reply

Return to “Club News and Announcements”