[Mk2] [Turbo] Link G3 Fitting

[bri0905]

Hi

Just purchased MartinF's link g3 with map sensor and 800 injectors.

He's kindly supplied it with the loom from ecu right through to the engine so I could either swap them over or see where to modify my loom to fit the link.

What i'd like to do is have a Harness adaptor to plug from my std loom into the link without any cutting of my loom but I don't think link sell them anymore as the g3 is old to them.

So, can I buy the connectors anywhere to make one? Anyone done this?

Any suggestions welcomed.

Bri

[Turbonoz]

I made my own patch harness & housed it in a stock ECU casing. For the connectors, I bought the cheapest ECU I could find and used it for parts.

[mr2magic]

Housings from toyota (almost all are still available) Terminals from theplugdealer.com, ballanger motorsports or cycleterminal. My selfmade main body loom is made from such parts

[/img]

[bri0905]

Great, didn't think toyota would be able to help.

So they can get me the female connecter as per the bottom of the ecu?

[2mad]

I made my own patch harness & housed it in a stock ECU casing. For the connectors, I bought the cheapest ECU I could find and used it for parts.

Smart smart smart

[mr2magic]

...
So they can get me the female connecter as per the bottom of the ecu?

Ahh you see the male connector isn't available directly from toyota I'm pretty sure the whole 3 connector pcb assembly is available from AMP/Tyco but you'd have to ask (theplugdealer may be the best to ask).

Other than that .... what turbonoz wrote!