![](./images/smilies/spacer.gif)
Right.
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
The 2 is currently running a CT20b with an aftermarket FORGE actuator of which is not working.
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
I have another new aftermarket Turbo Dynamics but dont have the correct end piece so i am going back and fitting the standard toyota actuator.
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
The standard actuator has x2 pipes coming from the top of the housing, My FORGE/Turbo Dynamics only have x1 connection from the top.
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
Do i only use one of the two standard conections on the toyota actuator and then blank one of them off??
![](./images/smilies/spacer.gif)
The car is running a Gizzmo boost controller if this info helps?.
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
Any pics/info would be great thanks.
![](./images/smilies/spacer.gif)
![](./images/smilies/spacer.gif)
Best regards
![](./images/smilies/spacer.gif)
Craig