I am going to take off the covers from the underside of my Mr2 to service the car and check all ok below.
I have noticed that i have a few cable ties on rear cover so i suspect bots have been breaking before
I am going to get some new bolts to put in but i will not be back to the car until next week. ( store 20 miles away)
Can someone confirm the size of bolts i need. I know the heads are a 10 but what size to fit. Length and size
I have a tap and dye set but have never used it before. I will drill out any broken bolts but again can anyone tell me what size of Tap i would need to use to get new bolts in.
Sorry to seem a bit stupid but never used this before
cheers
[Mk2] [NA] underside covers help
Moderators: IMOC Moderators, IMOC Committee Members
-
- Posts: 417
- Joined: Tue Jan 22, 2008 12:28 pm
- Location: Cleveland
Re: [Mk2] [NA] underside covers help
Yes the heads are 10mm (socket size) the length is 10mm. The original toyota bolts work with a standard M6 tap.
I recall using a 4mm or 4.5mm drill.
Toyota sell replacement bolts for about 78p each. If I did mine again I would probably use stainless bolts and washers.
I recall using a 4mm or 4.5mm drill.
Toyota sell replacement bolts for about 78p each. If I did mine again I would probably use stainless bolts and washers.