Discussion and technical advice the SW20 MR2. 3S-GTE, 3S-GE, 3S-FE etc
Anything and everything to do with maintenance, modifications and electrical is in here for the Mk2.
I have a carbon blade to replace my standard one with (rev 5) there are 2 ordinary bolts plus one which looks looks it needs a special tool to get it off there is also a warning sticker saying that if this is removed the spoiler could be damaged? has anyone replaced this spoiler and could you shed some light on what i need to do to get this bolt out http://s18.photobucket.com/albums/b117/ ... =photo.jpg
Last edited by aliendoughnut on Sun May 02, 2010 11:38 am, edited 1 time in total.
I think it is because there is a change you bend the two end sides to far from eachother.
Tip: when you got one bolt out, support that side underneath with something.
success wow came off really easy looks really good i noticed that the original had a thin gasket between the edge of the blade and the spoiler did you use anything or just fit it without? i think some thin rubber might do the job just to seal the small gap
Just a flathead screw driver to remove I think. I presume the sticker is an obvious statement as the blade will fall out if the bolts aren't there!
You should be able to buy the thin foam pads from Toyota if you really feel you need them..
Thanks i will try mr t for the foam/rubber pads if i cant get them i should be able to make some. The original ones are really thin but i can get away without any. I will post some pics up tomorrow i would like some carbon fiber covers to replace the end covers too.. Better start looking