Discussion and technical advice the SW20 MR2. 3S-GTE, 3S-GE, 3S-FE etc
Anything and everything to do with maintenance, modifications and electrical is in here for the Mk2.
Hi Guys,
slight problem....I have a green plastic stwitch to turn my fogs on and off and I don't know it works. Does any know how it works or if this is a gypsy method? The MOT is being done now and thats the only thing they are going to fail it on...help!!
Thanks,
Ayshe
Rear fog lights require the switch to be illuminated too I believe.
If it doesn't work you'll need to check a few things. Basically the switch should be a 3 pin one. 1x 12v in, 1x ground & 1x 12v out.
If you've got 12v in and earth then you should also have 12v out and illumination when the switch is live. If that is the case and you still have no fog lights then your wiring to the back of the car is shot. Normally an SVA requirement on import so probaly just a piece of halfords wire run down under the drivers kick panel, and out over the rear arch somewhere to the rear lights.
First thing is to check the feeds to the switch.
If this is for the front fogs, they're not an MOT requirement so shouldn't fail on it.
Hope that helps,
Ant
On the same sort of topic - ive done a rev3 rear light conversion and at the moment ive got the 2 reversing lights in the rear panel wired different. the lhs one is used for reversing and the rhs one is wired as a fog light. For mot purposes, would i get away with just putting a red bulb in the rhs light in the centre panel and using that as the fog light and will this pass (i have seperate illuminated switch for rear fog light).