www.imoc.co.uk

Odin_S wrote:Hmm.... i don't remember the wooden steering wheel having an airbag.

Does it look like the one in the link below?

I think your right now I'm thinking about it, yep its the same as the one below.

Thanks
Connor

Hi Guys, Got a 1996 10th Anniversary Edition and I want to remove the steering wheel to get it reupholstered. Any idea how to take it off? I don't want to go trying to prise trim off with it being airbag and irreplaceable? Also is it a Momo boss underneath seems as the original wheel is momo or will...

Any chance of a picture?

Just checked part numbers on toyodiy.com and they are the same for the front and rear through all years 89-99 sw20. Interestingly enough it also lists as the same studs for the mk3 99-2005. Part number 90942-02049 12/1989-07/1999 TOYOTA MR2 SW20 41-02: REAR AXLE SHAFT & HUB 43-03: FRONT AXLE HU...

Thanks it would be nice to know before I order them, Iv got a 1996 Uk 10th anniversary so not sure if its a rev 3 or 4?

The ones I got from epic are good quality but as I said just need something like 0.4 mm tickling off the splines. I actually managed to fit 8 on the front without but it was hard work and I managed to snap a couple before I realised if I took off half a mil they would go in easier. The two I snappe...

The ones I got from epic are good quality but as I said just need something like 0.4 mm tickling off the splines. I actually managed to fit 8 on the front without but it was hard work and I managed to snap a couple before I realised if I took off half a mil they would go in easier. The two I snappe...

The ones I got from epic are good quality but as I said just need something like 0.4 mm tickling off the splines. I actually managed to fit 8 on the front without but it was hard work and I managed to snap a couple before I realised if I took off half a mil they would go in easier. The two I snappe...

Hi guys,

I'm after a set of extended wheel studs for the FRONT wheels on my MR2, ideally 10-15mm longer, really hoping someone on here knows the best place to get them?

If I'm correct I think I need M12 x 1.5 with a Spline of 12.4?
Also what is the length of the standard ones?
Thanks
Connor

Hi guys, iv recently acquired a 1996 MR2 10th anniversary edition and now neither of the front headlights will pop up, they both light up and I can raise them manually. Iv had a look in the front fuse box and they all seem to be okay? I'm not sure how I could check the relays though? Any thoughts or...