www.imoc.co.uk

AFM still avail?

metallica fish wrote:are you still after this?

I know a guy who does stand alone ECU's and might be able to help you (Sunderland)

Yes mate i am

Is there a standalone ecu avail for rev1 turbo that is either maf or speed density? Thanks

How much delivered?

About to remove lh/rh engine supports so Im pretty close to dropping the engine but wanting to know the best places to attach my chains. Can anyone show me these positions please? Thanks

markstevieandmads wrote:Mr2ben or ade from mr2bitz.

I'd also recommend tcbparts

Thanks

Im currently removing my engine from a non runner turbo rev1, but when I come to refit Im wanting to replace all the old parts for new uprated, this meaning all suspension arms bushes etc, I keep searching the net and egay trying to find a shop that specialises with these parts. Does anyone know a g...

The guage sender is on your water elbow...it's the smaller of the sensors and it's faceing the rear of the car iirc mate...if it's the sensor that fubared...I have one you can have for a fiver, may well be the plug or wiring though so check it out thoroughly...well important to have a water temp gu...

Heaters work fine.
Thanks

Cheers. I have just ground the sensor and the needle flies up, would that tell me anything (what to do next)?

My water temp oe gauge is not giving a reading, thought it might have been the gauge so I replaced this and still no reading, when I turn on the ign I can see the needle move slightly, is there anything I can check?

I am going to remove the AVCR in my car any minute now, but need to know how and where to couple vac pipes back up for actuator ect ect. Can anyone help, thanks.

Nice1. Enjoyed watching this.

Hello, haven't a clue where to post this but Im still new to MR2 ownership and still sorting out the mess which I bought, nearly there now though. Anyway I have now fitted a speedo converter and replaced the stupid blue LED lights in the cluster for standard but the speedo dial lights up different f...

Cheers.
I did do a search first I always do but the list was endless and Im at work.

Just got some new plugs for my turbo rev1. Its still nearly standard running a bit more boost and a couple of other small mods (0.85bar). Ive just got some BKR6EP-8 shall I gap these smaller or will .8 be fine?
Thanks in advance.

Anyone know what size socket/spanner I need for the large banjo bolt for the turbo oil feed pipe (rev1) as its a nightmare trying diff sockets ect whilst Im laid under the car. Thanks

All the best for 2011...
Ok so Im going to have to change my exhaust manifold, before I start this I thought I would ask if there maybe any special tools which might make the job easier other than a standard set of spanners and socket set.

Does anyone know who can change my exhaust manifold and not charge me the Earth.. This needs doing asap as 1 of the tubes has a crack in the weld nearly all around it. I live in the North East. Thanks.

djpkins wrote:check the thread..."help identifying my exhaust gasket" under this one

Thank You