[FINALIZED] toyobd1 and satnav carpc setup, plug and play kit.

[qwakers]

i have for sale my carpc setup i took out of my mr2.

it includes

a toyobd1 reader. this will fit any toyota engine pre OBD2. if you plug it into a 3vzfe then it'll be plug and play, if you plug it into anything else you'll have to delete the engine profile out of the software and add yours. this is really easy.



a tomtom gps receiver, already paired and setup to work with the tablet. and its power supply and a hardwire adaptor for hiding all the wiring in behind the dash


a tablet mount and cubby box to go below your radio.



a 3amp usb power supply with a adapter cable for the tablet. note, this may need replacing, i think a capacitor has blown, it squeals a bit. note to self, do not connect to permanent live next time, they dont live long with power applied and no load. they are about £1 on ebay.


a tablet pc running android with the following software installed:

maps.me : a open source mapping software to use as a gps software. i installed it as a backup but i didnt ever get round to trying it out

tomtom go, cracked so its fully activated with euro maps installed. i have tried this, it works very well.

bluetooth gps. this is a location data emulator to make the gps software work. you need to open this app whenever you want to use it as satnav, connect it and THEN open tomtom go.

TOYOBD1 the app for the toyobd data reader.





thats a lot of stuff



it is all nearly new, it is all fully working and it is very cheap at...


£55 posted.

[SonicSW20]

Remove the ?1 from the end of the link and add image tags, it'll work then.

[qwakers]

tried, didnt

edit now it does, had to delete it, re upload it and then NOT rotate it, so its on its side. nevermind.

[qwakers]

also, whilst i said itll be plug and play, that is not including the fact youll have to wire in the two power supplies into your loom. i used the ignition feed for the radio.

[Feedback Bot]

This Sale has been completed. The Buyer was lioneld