16" 114.3 PCD. Standard staggered set up, these are in good condition, but will need a refurb at some point. Good tread on fronts, just legal on backs. Collection only.
Can send pics on request.
£400
[FINALIZED] Enkei RP01's
Moderators: IMOC Moderators, IMOC Committee Members
Re: [FINALIZED] Enkei RP01's
Widths, offsets and center bore of wheels?
-
- Posts: 1167
- Joined: Wed Dec 15, 2004 7:50 pm
- Location: Midlands
Re: [FINALIZED] Enkei RP01's
Will take a look tonight mate, where will it tell me the offset?
Re: [FINALIZED] Enkei RP01's
robbie_742003 wrote:Will take a look tonight mate, where will it tell me the offset?
Should all be on the back of the wheel, then just measure the center bore. Helps determine what spigot rings would be required.
offset should be shown as, for example "ET38" or "+38", and the width shown as "7J" or "7x16" etc
-
- Posts: 1167
- Joined: Wed Dec 15, 2004 7:50 pm
- Location: Midlands
Re: [FINALIZED] Enkei RP01's
Hi mate,
We got 16x7JJ and 35 offset
and 16x8JJ and 38 offset
Just realised I forgot to measure the bore, I'll do it tonight.
Rob
We got 16x7JJ and 35 offset
and 16x8JJ and 38 offset
Just realised I forgot to measure the bore, I'll do it tonight.
Rob
-
- Posts: 1167
- Joined: Wed Dec 15, 2004 7:50 pm
- Location: Midlands
Re: [FINALIZED] Enkei RP01's
70mm on the bore Craig.
-
- Posts: 6071
- Joined: Wed Dec 15, 2004 10:16 am
Re: [FINALIZED] Enkei RP01's
This Sale has been completed. The Buyer was Non-Member