www.imoc.co.uk Forum Index
 AlbumAlbum CalendarCalendar FAQFAQ SearchSearch MemberlistMemberlist Legal NoticeLegal Notice IMOC 1/4 Mile1/4 Mile Table Knowledge BaseKnowledge Base   RegisterRegister 
 GarageCommittee GarageGarage  SubscriptionPremium Membership  ProfileProfile   Log in to check private messagesLog in to check private messages   Log inLog in 
Calendar 
Mallory fuel pressure reg etc.

 
Post new topic   Reply to topic       www.imoc.co.uk Forum Index -> Parts For Sale -> Mk2
View previous topic :: View next topic  
Author Message
Martin F
IMOC Moderator



Joined: 04 Aug 2006
Posts: 14606
Location: The Couch !
Feedback Score: 204

1994 Toyota MR2 Mk2 Turbo Rev3

PostPosted: Sat Nov 04, 2017 12:27 pm    Post subject: Mallory fuel pressure reg etc. Reply with quote Reply with quote including images

Mallory fuel pressure regulator, comes with gauge and all associated braided lines to be a direct fit for a rev 3 turbo, nothing else required.

This regulator, gauge, braided lines and all the connectors retail close to 300 so looking for 150 posted.
Will consider offers....







Last edited by Martin F on Mon Dec 11, 2017 3:05 pm; edited 1 time in total
Back to top
User is offline 
yokomomr4bx
Premium Member



Joined: 20 Jan 2013
Posts: 130
Location: Cardiff
Feedback Score: 4



PostPosted: Sun Nov 05, 2017 7:58 pm    Post subject: Reply with quote Reply with quote including images

Apologies for asking what may seem obvious to some, but I've never really researched this. I assume this regulator does not function off vacuum? What advantages over the stock regulation does this setup confer and would it beneficial on an otherwise stock fuel system that has been running 1.1bar for the past 3 years?

Thanks for your time!
Back to top
User is offline 
Martin F
IMOC Moderator



Joined: 04 Aug 2006
Posts: 14606
Location: The Couch !
Feedback Score: 204

1994 Toyota MR2 Mk2 Turbo Rev3

PostPosted: Sun Nov 05, 2017 8:53 pm    Post subject: Reply with quote Reply with quote including images

yokomomr4bx wrote:
Apologies for asking what may seem obvious to some, but I've never really researched this. I assume this regulator does not function off vacuum? What advantages over the stock regulation does this setup confer and would it beneficial on an otherwise stock fuel system that has been running 1.1bar for the past 3 years?

Thanks for your time!


Standard regulator is fine for a stock car, some even run them on higher powered cars. This set up wouldn't give you any benifits unless you were going for a lot higher power. [Sad]
Back to top
User is offline 
yokomomr4bx
Premium Member



Joined: 20 Jan 2013
Posts: 130
Location: Cardiff
Feedback Score: 4



PostPosted: Mon Nov 06, 2017 2:00 pm    Post subject: Reply with quote Reply with quote including images

Thankyou, hope sale goes well.
Back to top
User is offline 
Martin F
IMOC Moderator



Joined: 04 Aug 2006
Posts: 14606
Location: The Couch !
Feedback Score: 204

1994 Toyota MR2 Mk2 Turbo Rev3

PostPosted: Fri Dec 15, 2017 9:34 pm    Post subject: Reply with quote Reply with quote including images

yokomomr4bx wrote:
Thankyou, hope sale goes well.


Selling at half what it cost but not many people are upgrading these days so may be around for a while [Sad]
Back to top
User is offline 
Display posts from previous:   
Post new topic   Reply to topic       www.imoc.co.uk Forum Index -> Parts For Sale -> Mk2 All times are GMT
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group