A quick check on offset

Posts about anything do to with modifying your car such as fitting aftermarket parts, bodykit, or tuning the engine for more performance.

Moderators: IMOC Moderators, IMOC Committee Members

Post Reply
billy

A quick check on offset

Post by billy »

Hi,
I have found some alloys that I would like to fit to my Rev 1, but I would like to run the size by the gurus on the site before I willy it up....

Front - 17inch 7.5 wide, 215.40.17 offset 35
Rear - 17inch 7.5 wide, 235.40.17 offset 35

It is the offset that I was not sure about...will these fit OK or will I need any spacers or anything?

Thanks a lot for any advice....

They are ROTA Battle alloys by the way. :D
Andy Jones
Posts: 3271
Joined: Tue Dec 14, 2004 12:22 pm
Location: Oldham
Contact:

Re: A quick check on offset

Post by Andy Jones »

Hi Billy, They'll fit :)

Running the same width's & offset on mine. On rare occasions (very bad dip in road) the fronts do scrub against the plastic arch lining, But it is lowered 50mm :wink:
billy

Re: A quick check on offset

Post by billy »

Hi Andy,
Thanks very much for the reply.
That means I can order them with peace of mind.
Appreciate that a lot!

Regards

Billy
Post Reply

Return to “Modifications”