[Mk2] [NA] Omex rev limiter - connected but not working/no lights?

Anything to do with the electrics of the car.

Moderators: IMOC Moderators, IMOC Committee Members

Post Reply
Bittenfleax
Posts: 8
Joined: Sat Aug 06, 2016 8:12 pm

[Mk2] [NA] Omex rev limiter - connected but not working/no lights?

Post by Bittenfleax »

Hi,

I recently just installed an Omex rev limiter with the red wire going to the "Black/Red" wire and the blue to the "Black/White" wire. I also connected the ground to some default ground point in the middle of the rear boot. However, there are no lights on the Rev limiter and I went to 6000RPM (default rev cut value) and nothing.

What troubleshooting steps can I take to figure out what is wrong?

Thanks
Bittenfleax
Posts: 8
Joined: Sat Aug 06, 2016 8:12 pm

Re: [Mk2] [NA] Omex rev limiter - connected but not working/no lights?

Post by Bittenfleax »

Sorted.

The blue "quick splice connector" was not good enough and did not make a great connection.

I ended up making a Y joint out of wires/solder.
auzzam
Posts: 218
Joined: Fri Oct 16, 2015 11:20 pm
Location: London

Re: [Mk2] [NA] Omex rev limiter - connected but not working/no lights?

Post by auzzam »

did you fit this to a turbo? how hard was the wiring - where does it plug into?
Post Reply

Return to “Electrical”