![](./images/smilies/spacer.gif)
Jimbob wrote:Planning on.
![](./images/smilies/spacer.gif)
.
![](./images/smilies/spacer.gif)
.
![](./images/smilies/spacer.gif)
.
![](./images/smilies/spacer.gif)
.
![](./images/smilies/spacer.gif)
.
![](./images/smilies/spacer.gif)
.
![](./images/smilies/spacer.gif)
.
![](./images/smilies/spacer.gif)
.
![](./images/smilies/spacer.gif)
.
![](./images/smilies/spacer.gif)
.
![](./images/smilies/spacer.gif)
.
![](./images/smilies/spacer.gif)
.
![](./images/smilies/spacer.gif)
Pistons
Rods
HG
Cams
![](./images/smilies/spacer.gif)
(maybe rev3 valves too)
![](./images/smilies/spacer.gif)
Cheers mate,
![](./images/smilies/spacer.gif)
James
![](./images/smilies/spacer.gif)
OK, in that case, have a dig around on the US Forum for the length of the rods
![](./images/smilies/spacer.gif)
(gudgeon pin centre to big end centre).
![](./images/smilies/spacer.gif)
Because a guy called ChrisK developed a custom
![](./images/smilies/spacer.gif)
"long rod" conversion, those measurements should be easily available
![](./images/smilies/spacer.gif)
(as a comparison between the standard rod ratio and the custom one).
![](./images/smilies/spacer.gif)
If you use stock length rods, then the deck height shouldn't change
![](./images/smilies/spacer.gif)
(unless the pistons you get are for some reason taller from the gudgeon pin to the crown), so you don't need to worry about that or the HG thickness
![](./images/smilies/spacer.gif)
(other than for setting the desired CR).
![](./images/smilies/spacer.gif)
DON'T go for aftermarket cams intended for the Rev3 if you have an older Rev.
![](./images/smilies/spacer.gif)
Basically, the earlier heads didn't have enough space inside to run the longer lift of the Rev3 aftermarket cams
![](./images/smilies/spacer.gif)
(for example, compare the lift of HKS 272s for both a Rev1 and Rev3).
![](./images/smilies/spacer.gif)
Other than that, you should be OK.
![Very Happy :D](./images/smilies/icon_biggrin.gif)