Hi,
I have found some alloys that I would like to fit to my Rev 1, but I would like to run the size by the gurus on the site before I willy it up....
Front - 17inch 7.5 wide, 215.40.17 offset 35
Rear - 17inch 7.5 wide, 235.40.17 offset 35
It is the offset that I was not sure about...will these fit OK or will I need any spacers or anything?
Thanks a lot for any advice....
They are ROTA Battle alloys by the way.
A quick check on offset
Moderators: IMOC Moderators, IMOC Committee Members
-
- Posts: 3271
- Joined: Tue Dec 14, 2004 12:22 pm
- Location: Oldham
- Contact:
Re: A quick check on offset
Hi Billy, They'll fit
Running the same width's & offset on mine. On rare occasions (very bad dip in road) the fronts do scrub against the plastic arch lining, But it is lowered 50mm
Running the same width's & offset on mine. On rare occasions (very bad dip in road) the fronts do scrub against the plastic arch lining, But it is lowered 50mm
Re: A quick check on offset
Hi Andy,
Thanks very much for the reply.
That means I can order them with peace of mind.
Appreciate that a lot!
Regards
Billy
Thanks very much for the reply.
That means I can order them with peace of mind.
Appreciate that a lot!
Regards
Billy