Hi,
Head blew again between 3&4.
1) Does anyone know if the ca 3 mm diameter coolant holes in the block that point in between the cylinders are supposed to be blind or should there be a flow through them?
2) What is the size of the crankshaft/oil pump oil seal, presumably this can be prised out without removing the oil pump?
88 mk1b
Many Thanks
Jim
Head gasket trouble again
Moderators: IMOC Moderators, IMOC Committee Members
Re: Head gasket trouble again
jimzzr wrote:Hi,
Head blew again between 3&4.
1) Does anyone know if the ca 3 mm diameter coolant holes in the block that point in between the cylinders are supposed to be blind or should there be a flow through them?
Jim
Bad form replying to ones own post but looks like the answer is yes
http://www.toymods.org.au/forums/thread ... to-unblock
If I got a long drill , could I run it all the way through? How much difference does it actually make?
Jim